Conversations

Conversations 1 - 20 of 34
Photo of machiasiaweb
Bandwith control by Netfilter ACL
Hello, I am working on how to limit the bandwidth from ACL.  However, there are some problem there. Example, I need to limit the band...
  • 1 me too
  • 4 replies
  • Question
Photo of machiasiaweb
Ansible not able to overwrite the file
Hello, I following the KB https://support.cumulusnetworks.com/hc/en-us/articles/205014637-Ansible-Simple-Playbook-Example-with... to wh...
  • 1 me too
  • 9 replies
  • Question
Photo of machiasiaweb
Apply PBR via Quagga
Hello, I am writing PBR by using Quagga.   Question 1) However, I think suppose it require apply to route-map into interface?  I am us...
  • 2 me toos
  • 2 replies
  • Question
Photo of machiasiaweb
Now to rest the port without ifreload?
Hello, When working some wrong setup.  That caused both ADMIN and physical goes to DOWN status. Like ------- 37: swp34: <BROADCAST,MULT...
  • 1 me too
  • 3 replies
  • Question
Photo of machiasiaweb
Only allow VLAN 1 traffic
Hello, I am config the interface now with following setup. --- auto swp34 iface swp34         mstpctl-portadminedge yes         alias n...
  • 1 me too
  • 1 reply
  • Question
Photo of machiasiaweb
ifup/ifdown config under /etc/network/interfaces
Hello, I known that it has a command ifup/ipdown interface_name to control interface up/down Does there are same configure parameter...
  • 1 me too
  • 8 replies
  • Question
Photo of machiasiaweb
MLAG connection between different domain of MLAG
Hello, While studying the Dell power connect manual  http://downloads.dell.com/manuals/common/powerconnect_nx00-usingmlag-whtppr_en-us....
  • 1 me too
  • 2 replies
  • Question
Photo of machiasiaweb
MAC address ACL
Hello, I am designing a MAC address ACL which protect host with KNOW mac address plug into the switch. Could you please advise does fol...
  • 1 me too
  • 5 replies
  • Question
Photo of Naresh Thukkani
Can you please let me know if Cumulus linux already supports policy based routing based on DSCP etc as of now or in future road map?
Can you please let me know if Cumulus linux already supports policy based routing based on DSCP etc as of now or in future road map?
  • 1 me too
  • 7 replies
  • Question
Photo of machiasiaweb
What is meaning of 'vlan-raw-device bridge'?
Hello, While studying VRR setup at https://docs.cumulusnetworks.com/display/DOCS/Virtual+Router+Redundancy+-+VRR ==================== ...
  • 1 me too
  • 3 replies
  • Question
Photo of machiasiaweb
How to show which VLAN is bindling with Bridge?
Hello, I would like to check which VLAN is bindling at Bridge. However, I cannot see via using netshow CLI Does anyway to check? e.g...
  • 1 me too
  • 3 replies
  • Question
Photo of machiasiaweb
Vlan tagged host connect
Hello, When studying vlan tagged example https://docs.cumulusnetworks.com/display/DOCS/VLAN+Tagging https://support.cumulusnetworks.c...
  • 1 me too
  • 2 replies
  • Question
Photo of machiasiaweb
Error after added clag-id paramater
Hello, I am running testing with VX (version 3.2.1) under Vmware. However, got the following error and I put clad-id variable "error:...
  • 1 me too
  • 3 replies
  • Question
Photo of machiasiaweb
VRF mgmt vlan setup
Hello, I am working on change the vrf mgmt from untagged vlan to Tagged VLAN 10. But I am not sure is it correct for following reconfig...
  • 1 me too
  • 1 reply
  • Question
Photo of machiasiaweb
Support multi VLAN aware bridge
Hello, While studying VLAN aware mode https://docs.cumulusnetworks.com/display/DOCS/VLAN-aware+Bridge+Mode+for+Large-scale+Layer+2+Envi...
  • 1 me too
  • 2 replies
  • Question
Photo of machiasiaweb
Should I enable BPDU guard when connection to host machine?
Hello, I am using vlan-aware mode  which will going to connect host at port swp1.  Since it will no need to exchange spanning tree and a...
  • 1 me too
  • 1 reply
  • Question
Photo of machiasiaweb
switch-to-switch MLAG example?
Hello, Currently studying the MLAG guide https://docs.cumulusnetworks.com/display/DOCS/Multi-Chassis+Link+Aggregation+-+MLAG It mention...
  • 1 me too
  • 2 replies
  • Question
Photo of machiasiaweb
Different MLAG peerlink setup find
Hello, When studying MLAG connection from https://docs.cumulusnetworks.com/display/DOCS/Multi-Chassis+Link+Aggregation+-+MLAG https://...
  • 1 me too
  • 1 reply
  • Question
Photo of machiasiaweb
Avoid spanning tree looping.
Hello, I am design to plug new Cumulus switch into existing network.  To avoid looping and re-choosing the new root bridge.  I would lik...
  • machiasiaweb, 1 year ago

  • 1 me too
  • 0 replies
  • Question
Photo of machiasiaweb
How to Control Port Speed?
Hello, Could you please advise how to control special port speed which is not common?  Example: 20Mbps, 200Mbps, 300Mbps etc Thanks!
  • 1 me too
  • 4 replies
  • Question